DHCP로 주소도 받아와서 핸드폰에서는 문제없이 되는줄 알았는데
노트북에서 해보니 ssh는 permission denied가 뜨고, nginx로 띄워둔 홈페이지는 접근이 되지 않는다.
도대체 핸드폰에서는 어떻게 되었던 거지?
+ 2020.05.16
다시 정신 차리고 해보니 자기 자신 아이피를 넣고 있으니 안되지 -_-
문제없이 잘된다.
+
그리고 hw_mode=g로 설정을 해놔서 802.11n을 지원하는 녀석임에도 불구하고 54Mbps로만 잡힌다.
둘다 테스트를 추가로 해봐야 할 듯..
| # ieee80211n: Whether IEEE 802.11n (HT) is enabled # 0 = disabled (default) # 1 = enabled # Note: You will also need to enable WMM for full HT functionality. # Note: hw_mode=g (2.4 GHz) and hw_mode=a (5 GHz) is used to specify the band. #ieee80211n=1 # ht_capab: HT capabilities (list of flags) # LDPC coding capability: [LDPC] = supported # Supported channel width set: [HT40-] = both 20 MHz and 40 MHz with secondary # channel below the primary channel; [HT40+] = both 20 MHz and 40 MHz # with secondary channel above the primary channel # (20 MHz only if neither is set) # Note: There are limits on which channels can be used with HT40- and # HT40+. Following table shows the channels that may be available for # HT40- and HT40+ use per IEEE 802.11n Annex J: # freq HT40- HT40+ # 2.4 GHz 5-13 1-7 (1-9 in Europe/Japan) # 5 GHz 40,48,56,64 36,44,52,60 # (depending on the location, not all of these channels may be available # for use) # Please note that 40 MHz channels may switch their primary and secondary # channels if needed or creation of 40 MHz channel maybe rejected based # on overlapping BSSes. These changes are done automatically when hostapd # is setting up the 40 MHz channel. # HT-greenfield: [GF] (disabled if not set) # Short GI for 20 MHz: [SHORT-GI-20] (disabled if not set) # Short GI for 40 MHz: [SHORT-GI-40] (disabled if not set) # Tx STBC: [TX-STBC] (disabled if not set) # Rx STBC: [RX-STBC1] (one spatial stream), [RX-STBC12] (one or two spatial # streams), or [RX-STBC123] (one, two, or three spatial streams); Rx STBC # disabled if none of these set # HT-delayed Block Ack: [DELAYED-BA] (disabled if not set) # Maximum A-MSDU length: [MAX-AMSDU-7935] for 7935 octets (3839 octets if not # set) # DSSS/CCK Mode in 40 MHz: [DSSS_CCK-40] = allowed (not allowed if not set) # 40 MHz intolerant [40-INTOLERANT] (not advertised if not set) # L-SIG TXOP protection support: [LSIG-TXOP-PROT] (disabled if not set) #ht_capab=[HT40-][SHORT-GI-20][SHORT-GI-40] |
'embeded > raspberry pi' 카테고리의 다른 글
| rpi / android h264 streaming (0) | 2020.05.24 |
|---|---|
| hostapd 802.11n 설정하기 시도중 (0) | 2020.05.16 |
| RC카 node.js was 제작 1차 완료 (0) | 2020.05.14 |
| node.js raspi-pwm (0) | 2020.05.14 |
| node.js onoff (0) | 2020.05.13 |
