구차니의 잡동사니 모음

6.7 Squid result codes

The TCP_ codes refer to requests on the HTTP port (usually 3128). The UDP_ codes refer to requests on the ICP port (usually 3130). If ICP logging was disabled using the log_icp_queries option, no ICP replies will be logged.

The following result codes were taken from a Squid-2, compare with the log_tags struct in src/access_log.c:

TCP_HIT

A valid copy of the requested object was in the cache.

TCP_MISS

The requested object was not in the cache.

TCP_IMS_HIT

The client issued an IMS request for an object which was in the cache and fresh.

TCP_SWAPFAIL_MISS

The object was believed to be in the cache, but could not be accessed.

TCP_NEGATIVE_HIT

Request for a negatively cached object, e.g. "404 not found", for which the cache believes to know that it is inaccessible. Also refer to the explainations for negative_ttl in your squid.conf file.

TCP_MEM_HIT

A valid copy of the requested object was in the cache and it was in memory, thus avoiding disk accesses.

TCP_DENIED

Access was denied for this request.

TCP_OFFLINE_HIT

The requested object was retrieved from the cache during offline mode. The offline mode never validates any object, see offline_mode in squid.conf file. 

6.10 Hierarchy Codes

The following hierarchy codes are used with Squid-2:

NONE

For TCP HIT, TCP failures, cachemgr requests and all UDP requests, there is no hierarchy information.

DIRECT

The object was fetched from the origin server. 

#  TAG: nonhierarchical_direct

# By default, Squid will send any non-hierarchical requests

# (matching hierarchy_stoplist or not cachable request type) direct

# to origin servers.

#

# If you set this to off, then Squid will prefer to send these

# requests to parents.

#

# Note that in most configurations, by turning this off you will only

# add latency to these request without any improvement in global hit

# ratio.

#

# If you are inside an firewall then see never_direct instead of

# this directive.

#

#Default:

# nonhierarchical_direct on 

ffmpeg -y -i input -c:v libx264 -b:v 2600k -pass 1 -an -f mp4 /dev/null && \

ffmpeg -i input -c:v libx264 -b:v 2600k -pass 2 -c:a aac -b:a 128k output.mp4

$ ffmpeg -i viedeo.mp4 -b:v 2M -maxrate 2M -bufsize 1M  -c:a copy video_low.mp4