U-Boot 2010.12-00000-g9777ca6-dirty (Nov 26 2015 - 10:10:11) for Exynox4412
CPU: S5PC220 [Samsung SOC on SMP Platform Base on ARM CortexA9] APLL = 1000MHz, MPLL = 800MHz DRAM: 2 GiB
PMIC VERSION : 0x00, CHIP REV : 2 TrustZone Enabled BSP BL1 version: 20121128
Checking Boot Mode ... SDMMC MMC Device 0: 15193 MB MMC Device 1 not found *** Warning - using default environment
USB3503 NINT = OUTPUT LOW! ModeKey Check... run normal_boot No ethernet found. Hit any key to stop autoboot: 0 Exynos4412 # Exynos4412 # movi init 1 emmc reset... REVISION: 2.0 Manufacture ID 0x11 [ 7456MB ] NAME: S5P_MSHC4 Device: S5P_MSHC4 Manufacturer ID: 11 OEM: 100 Name: 008G9 Tran Speed: 0 Rd Block Len: 512 MMC version 4.0 High Capacity: Yes Size: 0MB (block: 7456) Bus Width: 8-bit DDR Boot Partition Size: 4096 KB Exynos4412 # run copy_uboot_sd2emmc reading FWBL1 ..device 0 Start 1, Count 30 MMC read: dev # 0, block # 1, count 30 ... 30 blocks read: OK completed eMMC OPEN Success.!! !!!Notice!!! !You must close eMMC boot Partition after all image writing! !eMMC boot partition has continuity at image writing time.! !So, Do not close boot partition, Before, all images is written.! writing FWBL1 ..device 1 Start 0, Count 30 MMC write: dev # 1, block # 0, count 30 ... 30 blocks written: OK completed eMMC CLOSE Success.!! reading BL2 ..device 0 Start 31, Count 32 MMC read: dev # 0, block # 31, count 32 ... 32 blocks read: OK completed eMMC OPEN Success.!! !!!Notice!!! !You must close eMMC boot Partition after all image writing! !eMMC boot partition has continuity at image writing time.! !So, Do not close boot partition, Before, all images is written.! writing BL2 ..device 1 Start 30, Count 32 MMC write: dev # 1, block # 30, count 32 ... 32 blocks written: OK completed eMMC CLOSE Success.!! reading bootloader..device 0 Start 63, Count 2048 MMC read: dev # 0, block # 63, count 2048 ... 2048 blocks read: OK completed eMMC OPEN Success.!! !!!Notice!!! !You must close eMMC boot Partition after all image writing! !eMMC boot partition has continuity at image writing time.! !So, Do not close boot partition, Before, all images is written.! writing bootloader..device 1 Start 62, Count 2048 MMC write: dev # 1, block # 62, count 2048 ... 2048 blocks written: OK completed eMMC CLOSE Success.!! reading 0 TrustZone S/W.. Start 2111, Count 312 MMC read: dev # 0, block # 2111, count 312 ... 312 blocks read: OK completed eMMC OPEN Success.!! !!!Notice!!! !You must close eMMC boot Partition after all image writing! !eMMC boot partition has continuity at image writing time.! !So, Do not close boot partition, Before, all images is written.! writing 1 TrustZone S/W.. Start 2110, Count 312 MMC write: dev # 1, block # 2110, count 312 ... 312 blocks written: OK completed eMMC CLOSE Success.!!
MMC write: dev # 1, block # 2423, count 32 ... 32 blocks written: OK |
