NMI 관련 CMOS(BIOS) 설정 페이지

여전히 NMI 관련한건 모르겠다 ㅠ.ㅠ
일단 용어 부터 조사를 해보자면 아래와 같은 약어들이 보인다.

----

PERR(Parity ERRor)
[링크 : http://ip.com/IPCOM/000010806]

IERR(Internal ERRor)
SERR(Signal ERRor)
[링크 : http://ibmss.tistory.com/entry/컴퓨터오류-IERR-과-SERR-오류-발생-의미]

FRB(Fault Resilient Booting)
[링크 : http://www.andovercg.com/datasheets/intel-SE7501WV2-motherboard-specs.pdf]

Table 13. System Management Submenu Options

Feature	Option	Description
Firmware SMIs	Disabled Enabled	Enables SMI generation.
System Event Logging	Disabled Enabled	Enables logging of critical events.
Clear Event Log	Disabled Enabled	Clears the System Event Log. This feature is reset to Disabled each time the system boots.
Memory Scrubbing	Disabled Enabled	Enables the system chip set to automatically detect and correct single-bit memory errors.
AERR Enable	Disabled Enabled	Enables the AERR signal.
Assert NMI on BERR	Disabled Enabled	Enables the BERR signal to be reported as a critical event via NMI. The Firmware SMIs option must also be enabled.
Assert NMI on PERR	Disabled Enabled	Enables the PERR signal to be reported as a critical event via NMI. The Assert NMI on SERR option must also be enabled.
Assert NMI on SERR	Disabled Enabled	Enables the SERR signal to be reported as a critical event via NMI.
Enable Host Bus Error	Disabled Enabled	Enables reporting of single-bit and multi-bit errors.
FPC Error Check	Disabled Enabled	If enabled, the BIOS verifies that it can connect with the front panel controller (control panel board) during system boot.
HSC Error Check	Disabled Enabled	If enabled, the BIOS verifies that it can connect with the Hot Swap Controller during system boot.
Server Management Information		Highlighting and pressing <Enter> selects the Server Management Information submenu.

[링크 : http://support.dell.com/support/edocs/systems/sdiam/en/sm/setup.htm]